![]() ![]() The first setting, Audio track, lets you choose which audio stream to use from the original video. If the original video(s) only have one audio track, you can simply ignore the Audio Track 2 tab. Then use Xmedia to do a direct copy from the. If they have copy protection, use MakeMKV to remove the copy protection, it will put the video in to a. But for some odd reason, when I only select the two front channels, the resulting stereo file combines all the 6 channels into two channels (oh, and I'd like to precise it's not specific to that one 5.1 audio file I'm using. There are two tabs so you can configure each audio track individually. If the mini DVDs dont have copy protection on them I think you can use them just with XMedia Recode to direct copy them to mp4. I've tried every other combination (Left front channel and center channel, Left rear channel and LFE channel, etc.), and everytime, the resulting stereo file does only contain the two channels I selected. The problem is they are swapped and this is what I would like to avoid. See picture below), I do get a stereo audio file with only the left and right front channels. The constant quantizer works fine, but not CRF. it is outputting my file in the same bit rate, around 3000 kbits. The funny thing I noticed is that if I swap the channels (basically attributing channel 1 to channel 2 and channel 2 to channel 1. Have any of you notice that the CRF setting in Recode 3.5.1.3 (using h.264) virtually has no change in the quality of the output file No matter CRF 16, 23, 10, etc. Now, the thing is, technically, the various channels are as follow:īut the problem I encounter is that when I attribute channel 1 (left front channel) to channel 1 and channel 2 (right front channel) to channel 2 in the channel order mode (see picture above), the resulting audio file is a stereo file that combines ALL the channels of the 5.1 file, and not just the left and right front channels. 3.3.7.4) to do some channel mapping, more specifically I'd like to create a stereo file using only the left and right front channels of a 5.1 audio track. ![]() So, I'm trying to use XMedia Recode (ver. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |